| ORBIT BABY INFANT CAR SEAT REPLACEMENT COVER AND CANOPY INSTALLATION INSTRUCTIONS Thank you for purchasing a NollieCover for your Orbit Baby infant car seat. Here are the steps for properly installing your new NollieCover onto your car seat: 1. Remove existing cover, canopy, and all other pieces that came with your car seat. If you have any questions, refer to your owner’s manual. If you do not have an owner’s manual: a. On the inside of the canopy, unzip the zipper and unsnap the snaps on the side. This will allow the canopy to be removed from the support bar. b. To remove the infant seat cover, un-Velcro the seat cover where the seatbelts are located in the front, and gently remove the cover. c. Remove the 2 side impact foam pieces that are located on the inside of your cover by un-Velcroing the back, upper portion of your car seat. They are found inside and are made of white, stiff foam. You will need to insert these back into your new NollieCover. 2. Now you are ready to put on your new NollieCover. Start with the seat first. Put the 2 side impact foam pieces that you removed in step 1.c. above, in the same locations in your new NollieCover. 3. Put NollieCover over the Orbit Baby infant seat. Feed the seatbelts through the seatbelt loops, and Velcro everything shut. Pull the buckle through the NollieCover. Now is a good time to install your Puddle Pad, Belly Pad and Seatbelt covers, and Infant Headrest if you have purchased them. 4. We have modified the canopy for a smoother fit. After unzipping and removing your original Orbit canopy from the plastic tension rod support in the front, you will find a small screw where the tension rod and bracket meet. This should be unscrewed while slipping on your NollieCover canopy, and then put the plastic tension rod back into the bracket and retighten screw. 5. You have completed installing your new NollieCover. Enjoy! If you have any problems, or questions, please contact us at 760-295-4383 or send us an email at nolliecovers@yahoo.com |